Bosch Appliances VMD01 M50 PAL General mounting notes, Mounting Variants, Housing vertical

2 Mounting

English

2.1General mounting notes

–Use only cable specified by the manufacturer. Protection against malfunction cannot otherwise be guaranteed.

–To guarantee operational safety, only those power supplies specified by the manufacturer may be used. (individual devices: power supply VMD–PS, for 19” installation, the power supply is integrated in the VMD–RA frame).

–For questions regarding setup, environmental conditions and safety of individual components, manufacturer documentation must be consulted.

–For installation, this instruction manual and the specific connection instructions are to be followed.

–This description does not contain information about installation and setup of the camera, monitor and recorder.

2.1.1Mounting Variants

Unit feet

1. Press in

2. Press in

			Locking
Feet	3. Press down with blunt	object	spring

Housing vertical

Four feet must be fitted to the unit base plate. The connecting cable must have sufficient strain relief.

Housing can be stacked upright.

Warning!

Maximum of four units can be stacked upright on top of each other.

If housings are stacked on top of each other, the feet on the underside of the housing must be fitted. There are no locking springs for the bottom unit. For all other units to be stacked, the locking springs must be pushed into the feet and pressed into the locating slits on the bottom unit. Ensure sufficient strain relief.

– 5 – A1 February 03/Trb