BM 2610027879
Adjustments
45° Bevel Stop – Adjustment procedure
!WARNING To avoid possible injury, disconnect plug from power
source before performing any assembly, adjustment or repair.
Checking 45° Bevel Stop Setting
1.Hold the saw head assembly down and push in the head assembly lock pin (item 43 – page 9) to keep the saw in the DOWN position.
2.Slide the head assembly completely to the back and engage the lock lever (item 27 – page 9) by lifting up the finger tab.
3.Rotate the table to the 0° miter position.
4.Pull up the bevel lock lever to unlock. Move the left sliding fence fully to the left.
5.Check the position of the bevel range selector knob; it should be at the
6.Tilt the saw assembly to the left (counterclockwise) until it hits the 45° stop – this is where the saw’s 45° stop is set to make a 45° left bevel cut.
7.Use a combination square to check that the blade is 45° to the table. Remove the rule blade from the combination square. Place only the combination square’s head on the saw’s table with its long flat side resting on the table and its 45° side against the tilted blade (see Figure 24).
Combination | Contacting | |
Blade | ||
Square Head | ||
|
Contacting Table
figure 24
8.Check that only the saw blade’s plate (not teeth) is touching the square’s 45° side. If the saw blade’s plate is not in full contact with the square’s head 45° side, follow the “Adjusting 45° Bevel Stop” procedures.
23.
