BM 2610027879
Troubleshooting
Troubleshooting Guide - Electrical
pROBlEM |
| CAUSE |
| CORRECTIVE ACTION |
|
|
|
| |
Brake does not stop blade in about | 1. Brushes not seated or lightly | - | Inspect/clean or replace | |
5 seconds. |
| sticking or worn. |
| brushes (see Maintenance |
|
|
|
| and Lubrication section). |
| 2. Motor overheated from use | - | Use sharp blade. | |
|
| of dull blade/too heavy of a | - | Use a recommended blade. |
|
| blade, not recommended | - | Let saw cool down. |
|
| accessory or rapid on/off |
|
|
|
| cycling. |
|
|
| 3. | Blade bolt loose. | - | Tighten blade bolt. |
| 4. | Other. | - | Authorized service. |
|
|
|
|
|
Motor does not start. | 1. | Check that unit is plugged in. | - | Plug unit in. Use different |
|
|
|
| outlet. |
| 2. Power source fuse or | - | ||
|
| time delay fuse. |
| circuit breaker. |
| 3. | Brushes worn. | - | See Motor Brush Replacement in |
|
|
|
| the Maintenance and Lubrication |
|
|
|
| section. |
| 4. | Other. | - | Authorized service. |
|
|
|
| |
Flash of light from motor endcap | Normal - brake working properly. |
| – | |
when switch is released. |
|
|
|
|
|
|
|
|
|
53.
