Bosch Power Tools CM10GD manual Adjusting 45 Bevel Stop Saw Blade 45 to Table

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 24

Adjustments

45° Bevel Stop – Adjustment procedure

!WARNING To avoid possible injury, disconnect plug from power

source before performing any assembly, adjustment or repair.

Adjusting 45° Bevel Stop (Saw Blade 45° to Table)

1.Pull up the bevel lock lever to unlock. Move the left sliding fence fully to the left.

2.Tilt the saw assembly to the left (counterclockwise) until it hits the 45° stop.

3.Place only the combination square’s head on the saw’s table with its long flat side resting on the table and its 45° side against the tilted blade.

4.Place an 8mm open end wrench on bolt head “F” (see Figure 25).

5.While turning bolt “F,” watch the blade tilt – turn “F” until the saw blade plate is in full contact with the 45° side of the square’s head (see Figure 24).

6.If needed, adjust bevel scale pointers (item 36 – page 9) to be in line with the bevel scale’s 45° lines. First, adjust right bevel pointer; then tilt saw head to the right 45° stop position (see page 41 – “Bevel Range 2 = 0-45° Right”) and adjust the left bevel pointer. Tilt the saw head to the 0° position

– both pointers should be on the bevel scale’s 0° lines.

7.Push down the bevel lock lever to lock at the desired bevel angle.

Adjusting Bevel Stops

figure 25

24.