BM 2610027879
Assembly
Attaching loose parts
!WARNING To avoid possible injury, disconnect plug from power
source before performing any assembly, adjustments or repairs.
|
| Miter |
|
| Detent Lever |
6 mm | Shaft |
|
Washer |
| |
| 10 mm |
|
| Washer |
|
Lock Nut |
|
|
| Bevel Lock | Miter |
| Lever | Lock Knob |
10mm Socket Tool | Hex Key |
|
|
| |
| figure 1 |
|
Attaching the Bevel lock lever – This miter saw is packaged with the saw head locked at 0° bevel angle. The bevel lock lever must be attached before operating the tool.
1.Slide the 10 mm flat washer over the shaft (area with flats).
2.Slide the bevel lock lever over the shaft, aligning the flats on the shaft to the flats on the lever’s mounting hole. The lever should be horizontal with the handle to the front (see Figure 1).
3.Slide the 6 mm flat washer over the shaft (area with screw threads) and against the recessed wall of the lever.
4.
5.Lift the bevel lock lever and push back down to check that the lever is securely in place.
Attaching the Miter lock Knob – Locate the miter lock knob from among the loose parts.
1.Look under the turntable’s front arm above the lock lever and locate the 10mm hole (see Figure 1).
2.Insert the long shaft of the miter lock knob through this hole until it stops.
3.Turn the knob clockwise (about 10 full revolutions) until it is tight or “locked.”
4.Loosen the knob 1/2 turn to unlock it. The table is now free to be moved on the base.
Using the Miter lock Knob –
1.Loosen the miter lock knob.
2.While holding the knob in your palm, reach down with your index or middle finger and pull up the detent lever. While gripping knob, rotate table left or right to needed miter angle and release the lever.
3.Tighten the knob once you are at the correct angle.
NOTE: It is recommended to tighten the miter lock knob before all cuts. It is required to tighten the knob before cutting at any angle between detent engagements or when the miter detent override system is in use.
Storing the 6/4mm Hex Key – There is a storage location on the saw to store the 6/4mm hex key. Insert the short leg of the hex key through the rubber grommet as shown. Place the long leg into the tool rest and press down into the retainer clip (see Figure 2).
NOTE: The 6/4mm hex key is needed to change the blade and to make tool adjustments. If lost, two separate hex keys may be substituted: a 4mm hex key and a 6mm hex key.
6/4mm
Grommet Hex Key
figure 2. Hex Key Storage
12.
