BM 2610027879
Transporting and Mounting
!WARNING To avoid injury, follow all statements identified below by
the BUllET (l) symbol.
•Unplug electric cord and wind up. Use the hook and loop strap to hold the wrapped cord together.
•Never lift the saw by gripping any of the mechanism parts. The saw may move and cause severe injuries to your fingers or hands.
•To avoid back injury, hold the tool close to your body when lifting. Bend your knees so you can lift with your legs, not your back. Lifting the saw from the back is the preferred method. This will tip the tool toward your body.
•Never lift tool by holding switch handle. This may cause serious damage.
•Never lift the miter saw by the power cord or the operational handle. Attempting to lift or carry the tool by the power cord will damage the insulation and the wire connections, resulting in electric shock or fire.
•place the saw on a firm, level surface where there is plenty of room for handling and properly supporting the workpiece.
ONlY lift this saw by the
Head Assembly
Lock Pin
Handle
| |
Carry |
|
Handle | Miter Lock Knob |
| |
Bevel Lock Lever |
|
figure 27
lifting Saw from Rear
1.Set bevel angle at 0° and lock in place using the bevel lock lever.
2.Rotate table to the extreme left position and lock in place using miter lock knob.
3.Push saw head back and lock in DOWN position using the head assembly lock pin.
4.Engage mechanism lock lever so the saw is locked in the retracted position.
5.Check that each base table extension is in the closed position and locked in place.
6.Use both hands and reach down to grip each cast- in carry handle. Whenever possible, lift from the back of the saw.
26.
