Bosch Power Tools CM12 manual New Auxiliary Fence, 21-3 6 Dia

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 31

Saw Operations

Crown Molding Auxiliary fence

Auxiliary fence - Using an Auxiliary Fence when cutting Crown molding flat on the table will reduce splintering of your workpiece and movement of small cut-off pieces. Remove the saw’s sliding fences (see page 21) before attaching the auxiliary fence.

Build auxiliary fence by following pattern below - Material: 3/4" x 1-1/2" wood. Add 4 holes as dimensioned on pattern -or- Add holes following the next steps:

1)Cut wood to the outside dimensions shown and temporarily attach to saw’s stationary fence using two C-clamps.

2)Use 1/4" drill bit to drill first through existing holes in the rear of the stationary fence and then through the wood.

3)Remove wood, countersink the front of the wood and permanently attach to saw’s fence with hard- ware shown below.

	21-3/4"
5/16 Dia. (4)
3-1/8"	5/16"	3-1/8"
7-1/4"		7-1/4"

FIG. 43

		FIG. 44
Nut (need 4)				New Auxiliary Fence
	Flat Washer (need 4)			Board: 3/4" Wide x 1-1/2" High
			5/16" Hole Through
			1/2" Countersink

1/4" Flat Head Machine Screw x 2-1/2" Long (need 4)

Stationary	Saw Base	Top of Base
Fence
		and Table

Note: The Stationary Fence is permanently attached to the Saw Base (do not remove)

-31-