BM 2610021316
Troubleshooting
Troubleshooting Guide - General
pROBlEM |
| CAUSE |
| CORRECTIVE ACTION | |
|
|
|
| ||
Blade hits table. | 1. Misalignment | - | Authorized service. | ||
|
|
|
| ||
Angle of cut not accurate. | 1. Misalignment | - | See Adjustments section. | ||
|
|
|
| ||
Cannot move miter adjustment. | 1. Lock knob tightened/detent | - | Loosen lock knob/move out | ||
|
| engaged. |
| of detent. | |
| 2. | Sawdust under table. | - | Vacuum or blow out dust. | |
|
|
|
| Wear eye protection. | |
| 3. | Blade interferes with fence. | - | Authorized service. | |
|
|
|
| ||
Head assembly will not fully | 1. Part failure. | - | Authorized service. | ||
rise or blade guard will not fully | 2. Pivot spring or guard spring | - | Authorized service. | ||
close. | |||||
- See Blade Installation page | |||||
|
| not replaced properly after | |||
|
|
| 10 & 11. | ||
|
| service. |
| ||
|
|
|
| ||
| 3. | Cover plate not tightened | - | Clean head assembly. | |
|
| after replacing blade. |
|
| |
| 4. Sawdust accumulation. | - | See cleaning page 34 | ||
|
|
|
| ||
Blade binds, jams, burns wood. | 1. Improper operation. | - | Replace or sharpen blade. | ||
Rough cuts. | 2. | Dull blade. | - | Replace with 12” diameter | |
| |||||
|
|
|
| blade designed for the mate | |
| 3. | Improper blade. |
| rial being cut. | |
| 4. | Bent blade. | - | Replace blade. | |
|
|
|
| ||
Tool vibrates or shakes. | 1. Saw blade not round. | - | Replace blade. | ||
| 2. Saw blade damaged. | - | Replace blade. | ||
| 3. | Saw blade loose. | - | Tighten blade screw. | |
| 4. | Other. | - | Authorized service. | |
|
|
|
|
| |
