Next Steps

If you’ve determined that a hardware component is not at fault and you are still having problems, it is most likely a software configuration or communication issue. Proceed to the appropriate advanced troubleshooting section for either the HP-UX Host or the HP Fabric Switch.

If you’ve configured your HP Fabric system to use IPoIB, refer to “Monitoring and Troubleshooting IPoIB” (page 121).

Monitoring and Troubleshooting the HP-UX Host

This section contains monitoring and troubleshooting information for the software configuration and communication of HCAs within the HP Fabric Clustering System.

HP-UX Host Troubleshooting Procedure

1.Ensure adapters are claimed by the host.

Run ioscan. Description: ioscan displays information about I/O devices on the host, including the software state of adapters. In the example below, options are applied to the command to display only HP Fabric adapters.

Syntax example: ioscan -fkC ib

Output example:

Class I H/W Path Driver S/W State H/W Type Description

============================================================================

ib

0 0/4/1/0/0/0 ib_t

CLAIMED

INTERFACE

HP InfiniBand HCA

2.Ensure that each adapter has the latest version of supported firmware. If it does not, you must update the firmware.

Run itutil. Description: itutil displays details about HP Fabric adapters on the host, which include the firware version. The firware version number is displayed in the output line item “IA Firware Version Number.”

Syntax example: itutil

Output example:

========================================================================

Number of Interface Adapters on this node: 1

========================================================================

 

Interface Adapter Name

: ib0

 

H/W Path

: 0/4/1/0/0/0

 

Transport Type

: IT_IB_TRANSPORT

 

IT API Version Number

: 1.0

IA

Software Version Number

: 1.0

IA

Firmware Version Number

: 3.1.0

 

Firmware Type

: Performance

IA supported

transport service types

: IT_RC_SERVICE

NOTE: This is a partial view of the itutil command output pertaining to this step in the troubleshooting procedure. For more information on the itutil command, see “Using Itutil” (page 56).

3.Ensure that each adapter port is connected and has an associated network address.

Run itutil. Description: itutil displays details about HP Fabric adapters on the host, which include the connection status and network address. The connection status is displayed in the output line item “Spigot Online.” The associated network address is displayed in the output line item “Primary Network Address.”

116 Monitoring and Troubleshooting

Page 116
Image 116
HP UX 11i v2 Networking Software manual Monitoring and Troubleshooting the HP-UX Host, Next Steps