HP UX 11i v2 Networking Software manual Show sensor

Usage Guidelines: This command can generate a large amount of data. Data is displayed per terminal length command settings. When executed, this command first prompts you to verify your desire to generate the data. Enter y to continue or n to cancel.

The default output file is syslog:igr_interface_runningstatus, where interface may be ib or all. If the file already exists, it will be overwritten. This text file may be uploaded to another system using the copy command or viewed using the more command.

Examples:

HP-IB> show running-status ib

Are you sure you want to continue? [yes(default) no]

Gathering system-wide information, please wait.....

HP-IB> show arp ethernet

================================================================================

ARP Information

================================================================================

port physical-address net-address type

--------------------------------------------------------------------------------

HP-IB> show arp ib

================================================================================

ARP Information

================================================================================

port physical-addressnet-address type

--------------------------------------------------------------------------------

HP-IB> show backplane

================================================================================

Backplane Seeprom

================================================================================

base-mac-addr chassis-id

--------------------------------------------------------------------------------

0:0:5:ad:0:0 0x2002

Press any key to continue (Q to quit)

Defaults: This command has no defaults.

Related Commands: See most of the other “show” commands.

show sensor

Synopsis: The show sensor command displays the temperature at several key locations within the system chassis.

Syntax: show sensor

Command Modes: User-execute and privileged-execute modes.

Privilege Level: General read-only user.

Usage Guidelines: The show sensor command identifies the temperature sensors in the system chassis. It also reports their location in the chassis and the current temperature at that location. Chassis temperature should be monitored to verify the cooling efficiency of the blowers and your data center air-conditioning.

Temperatures are in Celsius and vary depending upon their location.

Examples:

================================================================================

Sensor Information

================================================================================

sensor oper-status oper-code temperature(c)

--------------------------------------------------------------------------------

1/1 up normal 30

Defaults: This command has no defaults.

Related Commands: “show fan” (page 140) “show power-supply” (page 171)

172 Switch Command Line Interface