HP UX 11i v2 Networking Software manual Type, Syntax type type Table B-76 type Command Argument

mod is the program module in side the application. lev is the verbosity of the trace information returned. val is a decimal or hex value.

card is the slot number of the card being traced.

Command Modes: Global-configuration mode.

Privilege Level: General read-write user.

Usage Guidelines: The number of applications and modules may change between releases. The numbers assigned to applications and modules may also change. Check application and module number assignments using CLI help (i.e.,?) before executing this command, as shown in the example below.

Examples:

HP-IB(config)# trace app ?

app <1-25>
app numbers:
APP_ID_CLI	= 1
APP_ID_OSPF	= 2
APP_ID_RIP	= 3
…
…
APP_ID_IP_AGENT	= 22
APP_ID_FIB_AGENT	= 23
APP_ID_KERNEL	= 24
APP_ID_CARD_AGENT	= 25
APP_ID_SM	= 26

HP-IB(config)# trace app 4 module 36 level very-verbose flowmask 0x12 card 2

Defaults: This command has no defaults.

Related Commands: “show trace” (page 174)

type

Synopsis: The type command defines the type of gateway or switch cluster connection being configured.

Syntax: type type

Table B-76 type Command Argument

Argument	Description
type	type may be one of the following:

•controllerIb12port4x (90-only controller)

•ib12port4x (12-port 4X InfiniBand)

Command Modes: Configuration Card (config-card) mode.

Privilege Level: Unrestricted or card-specific read-write user.

Usage Guidelines: The card type must be specified before it may be enabled. Examples:

HP-IB Example:HP-IB(config-card-2)# type en4port1G

Defaults: InfiniBand switch cluster connection type does not have to be specified because it is automatically detected and configured when the system boots up.

Related Commands: “shutdown” (page 208) “show card” (page 136)

212 Switch Command Line Interface