HP UX 11i v2 Networking Software manual InfiniBand Commands, Ib sm subnet-prefix, Arp ib, Clear ib

local routes are automatically created when you assign an IP address to a system card or port. Some gateway functions are not supported by HP InfiniBand..

Examples:

HP-IB# configure

HP-IB(config)# ip route 192.168.3.0 255.255.255.0 10.10.1.0

Defaults: The default is an empty string.

Related Commands: “show ip” (page 168)

InfiniBand Commands

This chapter describes InfiniBand CLI configuration commands, which are used to administer the system chassis.

The commands described here cover are all the InfiniBand-related commands, with the exception of IPoIB commands. The IPoIB commands are covered in “IP Commands” (page 177).

The commands described in this chapter are listed in the table below, and described in alphabetic order. Not all commands are available to users with limited privileges. Users with limited access privileges can only display and use a subset of the commands displayed in this section.

The commands are broken-up into two different types:

•InfiniBand Subnet Management Configuration Commands

•InfiniBand Interface Configuration Commands

Table B-45 InfiniBand Commands

Command		Description
arp ib		Assigns static ARP addresses to InfiniBand interface ports. See “arp ib”
		(page 177)
clear ib		Assigns static ARP addresses to InfiniBand interface ports. See “clear
		ib arp-cache” (page 178)
ib sm subnet		Used to administer the Subnet Managers for the switch fabric. See “ib
prefix		sm subnet-prefix” (page 182)
ib-agent	channel adapter	Used to configure the Subnet-Management Agent (SMA) node strings
		for channel adapters. See “ib-agentchannel-adapter” (page 185)
	switch	used to configure the Subnet-Management Agent (SMA) node strings
		for internal switches. See “ib-agent switch” (page 185)
interface ib	exit	Use to exit the current mode. See “exit” (page 197)
	gateway	Configure the IB virtual gateway. See “gateway” (page 198)
	help	Shows command help. See “help” (page 199)
	history	Shows command history. See “history” (page 199)
	link-trap	Enables/Disables link-traps. See “link-trap ” (page 186)
	name	Assigns names to FC interface cards. See “name” (page 187)
	no	Negate a command, or set its default.
	shutdown	Enables or disables interface cards. See “shutdown” (page 187)

ib sm subnet-prefix

Synopsis: The ib sm subnet-prefixcommand is used to administer the subnet managers for the switch fabric. This includes creating Partitions and adding members to those Partitions.

Syntax: ib sm subnet-prefix guid [priority priority] [sm-key sm-key][response-timeout timeout] sweep-interval interval]

182 Switch Command Line Interface