HP UX 11i v2 Networking Software manual Oper-status, Link-trap

Table B-31 show interface ib Output Descriptions (continued)

Field	Description
oper-status	Indicates if the port is physically ready for configuration and use. The value of this field may be up
	or down. If this field is down but the admin-status is up, check that the InfiniBand interface card is
	securely seated in the slot and a cable is attached between the port and the target InfiniBand host.
link-trap	Indicates if connection link errors are to be captured and sent to trap recipients. The value may be
	either enabled or disabled. This field is set by the config interface ib link-trap command.

The administrative (admin) status, speed, and connection-type reflect the values you had assigned. The operational (oper) status, speed, and connection-type reflect the values derived from the physical hardware and its connections. This allows you to verify your configuration settings against the actual hardware. The admin/oper pairs do not have to match for you to use the card. However, if there is a mismatch, the oper value is used.

Examples: The following example shows the output of the show interface ib command without the sma sub-command or statistics keyword.

HP-IB# show interface ib 15/1

===============================================================

InfiniBand Interface Info

==============================================================

port : 15/1

name : 15/1

type : ib4xTX

desc : 15/1 (961)

last-change : none mtu : 4096

admin-status : up oper-status : down oper-speed : unknown oper-duplex : unknown

link-trap : enabledHP-IB#

The following example shows the output of the show interface ib command with the statistics keyword.

HP-IB# show interface gate 4 statistics

===============================================================

InfiniBand Interface Statistics

===============================================================

gateway : 4

name : 4/0 (256) in-octets : 0

in-ucast-pkts : 0 in-multicast-pkts : 0 in-broadcast-pkts : 0 in-NUcast-pkts : 0 in-discards : 0 in-errors : 0 in-unknown-protos : 0 out-octets : 0 out-ucast-pkts : 0 out-NUcast-pkts : 0 out-multicast-pkts : 0 out-broadcast-pkts : 0 out-discards : 0 out-errors : 0 out-QLen : 0

HP-IB#

Defaults: This command has no defaults.

Related Commands: “interface ib” (page 186) “ib-agent switch” (page 185)

164 Switch Command Line Interface