HP UX 11i v2 Networking Software manual Show interface mgmt-ethernet, Show interface mgmt-ib

out-ucast-pkts : 39 out-multicast-pkts : 0 out-broadcast-pkts : 0 out-discards : 0 out-errors : 0

HP-IB>

Defaults: This command has no defaults.

Related Commands: “show interface ib” (page 163) “show interface ib sm” (page 165)

show interface mgmt-ethernet

Synopsis: The show interface mgmt-ethernetcommand shows the configuration of the Ethernet Management port on the system controller.

Syntax: show interface mgmt-ethernet

This command takes no card or port designation.

Command Modes: User-execute and privileged-execute modes.

Privilege Level: General read-only user.

Usage Guidelines: The Ethernet Management port is an Out-of-Band Management (OBM) port that provides network access to the system chassis in order to run remote CLI and Element Manager sessions. The port must be configured before it can be used (Element Manager GUI is not supported in initial release of HP InfiniBand).

This command displays the administrative status of the interface port, its assigned IP address and subnet mask, plus the IP address of the gateway port used to connect to the Ethernet Management port. If the Ethernet host is directly connected to the Ethernet Management port, without having to go through Ethernet switches, the default gateway-addr value is 0.0.0.0 (some gateway functions are not supported by HP InfiniBand).

Examples:

HP-IB# show interface mgmt-ethernet

===============================================================

Mgmt-Ethernet Information

===============================================================

mac-address : 00:05:ad:00:11:75 auto-negotiate : enabled

admin-status : up ip-addr : 10.3.102.24

mask : 255.255.0.0 gateway-addr : 10.3.0.1

HP-IB#

Defaults: This command has no defaults.

Related Commands: “interface mgmt-ethernet” (page 202)

show interface mgmt-ib

Synopsis: The show interface mgmt-ibcommand displays the status and address information for the virtual Management-InfiniBand port.

Syntax: show interface mgmt-ib

This command takes no card or port designation.

Command Modes: User-execute and privileged-execute modes.

Privilege Level: General read-only user.

Usage Guidelines: Refer to the “Install HP Fabric Clustering System Switches” (page 41) for information regarding Interface Management IB port.

Examples:

HP-IB# show interface mgmt-ib

===============================================================

Show Commands 167