HP UX 11i v2 Networking Software manual Ftp-server enable Use to enable or disable ftp-services

Table B-54 Administrative Commands (continued)

Command	Description
exit	Used to leave the current mode for the previous mode or the user-execute mode.
	See “exit” (page 197)
ftp-server enable	Use to enable or disable ftp-services.
	See “ftp-server enable” (page 197)
gateway	Gateway functions are not supported by HP InfiniBand
help	Describes the types of help information available and ways to display specific
	command-line information.
	See “help” (page 199)
history	Shows command history. See “history” (page 199)
hostname	Assigns a name to the system. See “hostname” (page 200)
install	Installs a downloaded system-image to the appropriate locations. See “install” (page 200)
interface	Used to enter a sub-command mode in which to configure InfiniBand interface cards, as
	well as chassis management connections. See “interface” (page 201)
interface	Enables and configures the IP addresses for the port and gateway of the out-of-band
mgmt-ethernet	Ethernet port, which is used to administer the chassis (some gateway functions are not
	supported by HP InfiniBand). See “interface mgmt-ethernet” (page 202)
interface mgmt-ib	Used to enable and configure the IP addresses for the virtual port and gateway on the
	InfiniBand fabric (some gateway functions are not supported by HP InfiniBand). See
	“interface mgmt-ib” (page 203)
ip	Configures the IP address and subnet mask for a virtual in-band InfiniBand port. See “ip
	” (page 203)
location	Used to assign a human-readable identifier to the system chassis. See “location” (page 204)
login	Used to change user identity during a CLI session. See “login” (page 205)
logging	Configures active log.
	See “logging” (page 205)
logout	Ends the current CLI session. See “logout” (page 205)
more	Displays text data on the terminal screen for a stored log or configuration file. See “more”
	(page 206)
no	Negate a command, or set its default.
ntp	Specifies the NTP servers to use to set and synchronize the system clock. See “ntp”
	(page 206)
ping	Verifies if a host can be reached from the system. See “ping” (page 207)
radius server	Configures a radius-server. See “radius-server” (page 207)
reload	Reboots the chassis. See “reload” (page 208)
shutdown	Enables or disables a specific interface card in the system chassis or the InfiniBand
	Management Interface. See “shutdown” (page 208)
snmp-server	Allows you set contact, location, and SNMP trap receiver information. See “snmp-server”
	(page 209)
telnet	Use to enable or disable access to telnet services. See “telnet” (page 210)
terminal length	Sets the number of lines displayed at one time by commands like more so that data does
	not scroll quickly out of view. See “telnet” (page 210)

Administrative Commands 189