HP UX 11i v2 Networking Software Defaults show card defaults to show card all, Oper status, Card

Table B-5 show card Command Field Descriptions (continued)

Field	Description
oper status	Operational status, as detected by the controller. This is the true status of the interface card based
	upon self-detection. The value of this read-only field is unknown, up, down, or failure. up indicates
	the card is ready to be configured. There may be situations when the admin status is up, but the
	oper status is something else. Both admin status and oper status must be up for you to configure
	the card.
oper code	General state of the interface card. The value is unknown, normal, wrong-image, bootFailed, tooHot,
	or booting. The Operational State must be normal before the Current Card Status can switch to up.
	unknown indicates an unsupported interface card - replace the card with a supported card.
	wrong-image indicates a system-image on the interface card that does not match the system-image
	on the controller. All cards must run the same system-image as the controller. bootFailed indicates
	that the system-image was incompletely or incorrectly loaded - if the other interface cards came up
	successfully, reset the individual card, otherwise, reboot the entire system chassis. tooHot indicates
	overheating - check that the fans are operational and open Health->Status… to the Sensors tab and
	note the card temperatures. booting indicates the card is still in the process of loading necessary
	image data for internal configuration.
slot	Slot number the card occupies.
product serial	Factory-assigned product serial-number.
number
pca	Printed Circuit-Assembly (PCA) serial-number.
serial-number
pca number	Printed Circuit-Assembly (PCA) assembly-number.
fru number	Field-replaceable unit-number.
Examples:	To display the configuration and status information for the card:

HP-IB> show card

================================================================================

Card Information

================================================================================

admin	oper	admin	oper	oper
slot type	type	status	status	code

--------------------------------------------------------------------------------

1	controllerIb12port4x	controllerIb12port4x up		up	normal
2	fc2port2G	fc2port2G	up	down	booting

================================================================================

Card Boot Information

================================================================================

boot	boot	boot
slot stage	status	image

--------------------------------------------------------------------------------

1	done	success	Release-1.1.3hp/build020
2	exe	in-progress

================================================================================

Card Seeprom

================================================================================

product	pca	pca	fru
slot serial-number	serial-number	number	number

--------------------------------------------------------------------------------

1	USC040200002	CS-0348-000083	95-00021-01-B2	AB291-62001
2	USP3390020FC102B5	PY-0339-000007	95-00008-02-C3	98-00021-01

Defaults: “show card” defaults to “show card all”

Related Commands: “boot-config” (page 190) “card” (page 192)

Show Commands 137