last-image-source : Release-1.1.3hp/build025 primary-image-source : Release-1.1.3hp/build025 image : Release-1.1.3hp/build025

cpu-descr : PPC 440GP Rev. C - Rev 4.129 (pvr 4012 0481) fpga-firmware-rev : 6

ib-firmware-rev : 5.1.0

HP-IB#

5.(Optional) The system can only hold one installed image, and one uninstalled image. If there are more than two images on your system, delete any extraneous images before proceeding with an installation.

3. Copy/Download the ImageThere are two ways that the software can be downloaded from the CLI:•Through an FTP server ((page 87)).•Through a TFTP server ((page 87)).

Download From an FTP Server Use FTP to download new image files to the HP Fabric Switch system. Uninstalled system-image files always end with a .img extension. Directory management is automatically performed on the switch system, so do not include path information for files on the switch chassis.

1.(optional) If you are using In-Band Management, configure the IP management interface (if you have not already done so).

HP-IB> enable HP-IB# config

HP-IB(config)# interface mgmt-ether HP-IB(config-if-mgmt-ethernet)#ip address 10.3.102.8. 255.255.0.0 HP-IB(config-if-mgmt-ethernet)#gateway 10.3.0.1 HP-IB(config-if-mgmt-ethernet)#no shutdown HP-IB(config-if-mgmt-ethernet)# exit

HP-IB (config) # exit

2.Verify that you have a working ftp server connection, and that you have a user account on the ftp server.

$ftp 10.10.0.5 username:Example password:xxxxxx ftp>

3.In the privileged-execute mode, enter the copy command with the source, destination, and FTP user information.

Syntax:

HP-IB> enable

HP-IB# copy ftp://user-name:password@source-IP-address/source-image-file-path-name image:destination-file-name

Enter path, user-nameand password information.

This information authenticates you to the server, which is specified in source-IP-address.

•Include the full path to the file.•Set the file-system to image when copying image files.

HP-IB# copy ftp://root:infini@15.13.113.96/tmp/HP-AB291A-Release-1.1.3hp-build020.img image:HP-AB291A-Release-1.1.3hp-build020.img

operation completed successfully HP-IB#

4.Continue on to “4. Install a New Image ” (page 88) to make the image active.

Download From a TFTP Server Use TFTP to download new image files to the system. Uninstalled system-image files always end with a .img extension. Directory management is automatically performed on the system, so do not include path information for files on the chassis.

Switch Administration and Management 87