HP UX 11i v2 Networking Software manual Show interface ib, Syntax is described in the table below

def-mcast-pri-port : 255 def-mcast-NP-port : 255 life-time-value : 11 port-state-change : 0

lids-per-port : 0 partition-enf-cap : 64

Defaults: This command has no defaults.

Related Commands: “ib sm subnet-prefix” (page 182) “show ib sm configuration” (page 141)

“show ib-agent switch” (page 156)

show interface ib

Synopsis: The show interface ib command displays the IP parameters and statistics for ports on InfiniBand interface cards.

Syntax: show interface ibcard/port all [sma args] [statistics]

The syntax is described in the table below:

Table B-30	show interface ib Command Syntax Descriptions
Syntax	Description
card/port	Refers to an individual card#/port# pair, a range of cards/ports, a list of cards/ports, or the keyword
	all.
all	Use instead of entering individual card#/port# pair, or a range of cards/ports
sma args	The sma sub-command displays the attributes and table data for subnet management agents that
	access InfiniBand ports. For an explanation of the sma sub-command, see “show interface ib sma”
	on page 102.

statistics The statistics keyword displays network statistics for the InfiniBand port on the interface card. The information displayed is octets, unicast and multicast packets, discarded packets, protocol errors, etc.

Command Modes: User-execute and privileged-execute modes.

Privilege Level: InfiniBand read-only user.

Usage Guidelines: Without the optional sma sub-command or statistics keyword, the show interface ib command displays general information about the InfiniBand interface port, such as its administrative status, its operational speed and status, and duplex mode.

The output fields of the show interface ib command are described in the table below.

Table B-31	show interface ib Output Descriptions
Field	Description
port	Identifies the InfiniBand interface card and port. The format is card#/port#.
name	User assigned name. If no name is assigned, the port name is displayed instead. This field is set by
	the config interface ib name command.
type	Identifies the type of the InfiniBand card. Supported cards are ib1xTX, ib1xFX, ib4xTX, and ib4xFX.
	This field is set by the config card type command.
desc	Text description of the InfiniBand port. The default is the port identifier in the form slot#/card#.
last-change	Time at which the InfiniBand port configuration was last changed.
mtu	Maximum Transmission Unit for the InfiniBand port. Used to configure the MTU size of IP network
	traffic.
admin-status	Indicates if you have enabled the port for configuration and use. The value of this field may be up
	or down. The default is down. The field is set by the config interface ib shutdown command.

Show Commands 163