HP UX 11i v2 Networking Software manual Configuration, Interfaces

Installing the AH304A Host Channel Adapter	36
Installing the 410533-B21 Host Channel Adapter	37
Installing the AD313A Host Channel Adapter	37
Installing the AB286C Host Channel Adapter	38
On-Line Addition and Replacement Operations (OL*)	39
Replacing an HP Fabric Clustering System HCA (HP-UX 11i v2 only)	39
Install HP Fabric Clustering System Software	40
Install HP Fabric Clustering System Switches	41
Rack Mount Preparation	41
Installing the Switch	42
Remove Shipping Sleeve	44
Remove Support Bracket (if installed)	44
Attach Cable Guides & Cables	45
Cable Routing and Bend Limits	45
Attach Cables	46
Attach to other HP Fabric devices:	47
Switch Setup	47
Connect Cables to Switch	47
Setting up the Switch	48
Internet Protocol over InfiniBand (IPoIB)	49
5 Configuration	51
Supported Features	51
Configuration Parameters	51
Non-Supported Features	52
Supported Configurations	52
Sample Configurations using the AB286A/C or AD313A HCA	52
Configurations up to 24 End Nodes	52
Configurations with More Than 24 End Nodes	53
6 Administration and Management	55
HP-UX Host Administration and Management	56
Using Itutil	56
Summary of Itutil Command Options	57
Itutil Syntax	57
Itutil Administrative Commands	57
Itutil Management Commands	58
Displaying Connectivity Information Using Itutil	63
Viewing the Itutil Manpage	65
Using NetTL	65
IB Tracing	67
IPoIB Tracing	67
IPoIB Administration and Management	67
nwmgr Utility	67
ifconfig Command	67
lanadmin Commands	68
lanscan Command	71
Serviceguard and IPoIB	71
Introduction	71
Using Serviceguard and IPoverIB	72
Configuring IPoIB Interfaces for Serviceguard Clusters	72
Configuring and running Serviceguard or Serviceguard Extension for RAC with IPoIB
interfaces	73

4Table of Contents