HP UX 11i v2 Networking Software manual Show boot-config, Defaults This command has no defaults

================================================================================

Backplane Seeprom

================================================================================

base-mac-addr chassis-idchassis-guid

--------------------------------------------------------------------------------

0:d:9d:fe:1a:2e 0xd9dfffffe1a2e 0xd9dfffffe1a2e

================================================================================

Backplane Seeprom

================================================================================

product	pca	pca	fru
serial-number	serial-number	number	number

--------------------------------------------------------------------------------

US2043000060 C2042700040 95-00026-01-B3 AB399-62001

Defaults: This command has no defaults.

Related Commands: “show boot-config” (page 135) “show card-inventory” (page 138)

show boot-config

Synopsis: The show boot-configcommand lists the image and configuration files that are used to initialize chassis firmware and configure the interfaces.

Syntax: show boot-config

Command Modes: User-execute and privileged-execute modes.

Privilege Level: General read-only user.

Usage Guidelines: This command lists the files that were used to bring-up the system, the files to use the next time the system is rebooted, and the backup files to use in the event that the primary boot files are not available.

The fields in the show boot-config output are described in the table below.

Table B-3 show boot-config Command Field Descriptions

Field	Description
slot-id	Slot identifier of the controller card in use. This value is either 1 or 14.
sw-version	Version of the software-image used to initialize chassis components.
last-image-source	Directory name of the system-image used to initialize chassis components.
last-config-source	Name of the file used to configure chassis interface cards and set system parameters.
primary-image-source	Name and directory location of the system-image to use to initialize chassis components the
	next time the system reboots.
primary-config-source	Name of the configuration file to use to restore the system configuration the next time the
	system reboots. This field is affected by the save running-config command.
secondary-image-source	Alternate image directory to use to initialize the system. This file is used if the file specified
	in primary-image-source is not available.
secondary-config-source	Alternate configuration file to use to restore the system configuration. This file is used if the
	file specified in primary-config-source is not available.

Examples:

HP-IB# show boot-config

============================================================================

System Boot Configuration

============================================================================

slot-id : 1

sw-version : HP-IBOS-1.1.3/build255 last-image-source : HP-IBOS-1.1.3/build255 last-config-source : running_config.cfg

Show Commands 135