HP UX 11i v2 Networking Software manual Help, History, Defaults The default gateway IP address is

The Management-InfiniBand gateway does not have to be specifically identified, like the gateways of expansion modules. This is because there is only one active Management-InfiniBand port on the chassis.

You must configure the Management-InfiniBand port through the serial-console terminal.

Examples: The following example shows the gateway command for the Ethernet management interface.

HP-IB# configure

HP-IB(config)# interface mgmt-ethernet

HP-IB(config-if-mgmt-ethernet)# gateway 10.3.0.94

The following example shows the ip address command in the InfiniBand management interface.

HP-IB# configure

HP-IB(config)# interface mgmt-ib

HP-IB(config-if-mgmt-ib)# gateway 10.3.0.94

Defaults: The default gateway IP address is 0.0.0.0.

Related Commands: “interface mgmt-ib” (page 203) “show interface mgmt-ethernet” (page 167)

“show interface mgmt-ib” (page 167)

help

Synopsis: The help command describes the types of help information available and ways to display specific command-line information.

Syntax: help

Command Modes: All modes.

Privilege Level: All users.

Usage Guidelines: This command may be executed in any mode. It provides the methods for you to display the various types of available help.

Examples:

HP-IB(config-if-ib-16/1-16/12)# help

Help may be requested at any point in a command by entering a question mark '?'. If nothing matches, the help list will be empty and you must backup until entering a '?' shows the available options.

Two styles of help are provided:

1.Full help is available when you are ready to enter a command argument (e.g. 'show ?') and describes each possible argument.

2.Partial help is provided when an abbreviated argument is entered

and you want to know what arguments match the input (e.g. 'show pr?'.)

HP-IB(config-if-ib-16/1-16/12)#

Defaults This command has no defaults.

Related Commands: None

history

Synopsis: The history command lists all the commands executed during the current CLI session.

Syntax: history

Command Modes: All modes.

Privilege Level: All users.

Usage Guidelines: The format of the history output and a configuration file are similar. The contents of the history may be cut-and-pasted to a text file and, with minor editing, used as a configuration file.

Administrative Commands 199