The safety and integrity designed into a machine can only be kept when the equipment is regularly examined for damage and repaired. It is the sole responsibility of the owner to make sure that regular maintenance is done. Worn or damaged components must be replaced immediately or the equipment removed from service until the repair is made. Only manufacturer supplied components must be used to maintain/repair the equipment.
Schedule Daily:
Weekly:
Monthly:
Before each use, inspect for loose, broken, damaged, or worn parts. Do not use the machine if any of these conditions exist.
Check for smooth roller operation. Clean the machine to remove dust, dirt, or grime. Do not use an automotive cleaner.
Make sure all bolts and screws and tighten if necessary.
NOTICE: To prevent damage to the finish of the machine or Console, do not clean with a petroleum based solvent when you clean. Prevent getting too much moisture on the Console.
Walking Belt and Deck Lubrication
The TreadClimber® machine is equipped with a low maintenance deck and belt system. Belt friction can affect the function and life of the machine. For the best results lubricate the Treadles periodically with a silicone lubricant, using the following instructions:
1.Unplug the machine fully from the wall outlet, and remove the power cord from the machine.
2.Apply a very thin layer of silicone lubricant on the Treadle deck below each belt. Carefully lift each belt and apply a few drops of the lubricant the entire width of the belt.
NOTICE: Always use a
3.Connect the power cord back into the machine and then into the wall outlet.
4.Stay to one side of your machine.
5.Switch on your machine and start the belts at the slowest speed. Let the belts operate for approximately 15 seconds.
6.Switch off your machine.
7.Take care to clean up any excess lubricant from the Treadles. We also recommend a periodic inspection of the Treadle surfaces below the belts. If the decks appear worn, contact a TreadClimber® Representative (refer to the Contacts page of this manual).
To decrease the possibility of slipping, be sure the Treadle area is free from grease or oil. Clean off any excess oil from the machine surfaces.
Use the following timetable as a guide to lubricate the decks:
•Light user (fewer than 3 hours / week): every 3 months
•Moderate user
•Heavy user (more than 5 hours / week): every month
We recommend that you use the following:
•8300 Silicone Spray, available at most Hardware and Auto Parts stores.
•
17
