|
| NOT OVER TIGHTEN. Replace |
|
| cover when finished. |
|
|
|
Knocking noises when unit is | Drive pulley and flywheel pulley | Unplug power from Unit. Wait at |
operating in TreadClimber® mode, |
| least 5 minutes. Remove plastic |
but not in treadmill mode |
| cover under treadles to expose “v” |
|
| belt drive line. Using a ½” wrench, |
|
| tighten the bolt that attaches the |
|
| 4 ½” drive pulley to the drive shaft |
|
| while holding the drive rollers |
|
| still. Also, using a 5/32” hex |
|
| wrench, tighten the set screw |
|
| on the flywheel motor pulley. |
|
| Reinstall plastic drive cover. |
| Igus bushing | If knocking sound seems to be |
|
| coming directly from the rear |
|
| roller, check igus bushings and |
|
| replace if cracked. |
| Hydraulic cylinder bolts | Check and tighten both upper |
|
| and lower bolts that connect the |
|
| hydraulic cylinders to the unit. |
Speed dependent grinding or | Belt alignment | Check walking belt alignment. |
scraping noise in all modes |
| Belt contact with metal guides |
|
| under Treadle can make loud |
|
| grinding sound. If belts are |
|
| misaligned follow belt alignment |
|
| procedure in Owner’s Manual. |
| Rollers or motor | Contact Customer Care for further |
|
| assistance. |
"Tick" sound once per revolution | Belt alignment | Belt seam may be contacting |
or scraping noise from under |
| metal belt guide under treadle. |
Treadle |
| Slight adjustment of belt should |
|
| alleviate noise. Follow belt |
|
| alignment procedure in Owner’s |
|
| Manual. |
Belts stop turning while in use | Safety key | Plug Safety Key into Console (See |
|
| Emergency Stop Procedure within |
|
| the Important Safety Precautions |
|
| section). |
| Motor overload | Unit may be overloaded and |
|
| drawing too much current, |
|
| causing unit to shut power down |
|
| to protect motor. Consult belt |
|
| lubrication schedule to determine |
|
| if belts need lubrication, check |
|
| walking belt tension, and restart |
|
| unit. |
22
