Contrast, Tint, Color, Blank screen | BOXLIGHT XD-10m instruction

U s i n g	t h e	P r o j e c t o r

NOTE: The color setting applies to video sources only. The tint setting applies to NTSC video sources only.

Contrast

The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image.

1Use the up and down arrows to highlight Contrast, press menu/select, use the arrows to adjust the contrast, then press menu/select to accept your changes.

Tint

The tint adjusts the red-green color balance in the projected image.

1Use the up and down arrows to highlight Tint, press menu/select, use the arrows to adjust the tint, then press menu/select to accept your changes.

Color

The color setting adjusts a video image from black and white to fully saturated color.

1Use the up and down arrows to highlight Color, press menu/select, use the arrows to adjust the color, then press menu/select to accept your changes.

Blank screen

Blank Screen determines what color is displayed when there is no active source and when the projector is in standby.

1Use the up and down arrows to highlight Blank screen, press menu/select, use the arrows to cycle through the options blue, black, and white, then press menu/select to accept your selec- tion.

18

Image 26

BOXLIGHT XD-10m manual Contrast, Tint, Color, Blank screen

Contents

Page EN 55022 Warning Safety CertificationsFCC Warning Canada Declaration of Conformity TrademarksPage Table of Contents Appendix Index Safety Terms Safety InstructionsSafety Definitions Safety Symbols Customer Service Important Operating Considerations Compatibility Image ResolutionIntroduction Unpacking the Projector T r o d u c t i o n Usage Guidelines Warranty If You Need Assistance Setting UP the Projector Make sure the projector and the computer are turned off T t i n g O j e c t o r Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the Projector T t i n g O j e c t o r Adjusting the Projector Using the ProjectorBasic Image Adjustment I n g O j e c t o r Using the Remote Control Source keypad only or Data and Video remote only Using the Keypad and Remote ButtonsMenu/select Forward/back buttons remote only Reset keypad onlyKeystone + remote only Up/down arrow buttons Using the On-Screen Menus Brightness Display MenuKeystone Color ContrastTint Blank screen Auto Image Image Menu for Computer SourcesResize Horizontal Position Manual SyncManual Tracking Vertical Position Image Menu for Video Sources Video Standard video sources only Auto Source Default SourceControl Menu Rear Projection ResetAdvanced Menu Language Menu Lamp hours used Computer resolutionStatus Menu Source I n g O j e c t o r Replacing the Projection Lamp Maintenance & TroubleshootingCleaning the Lens Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Replacing the Batteries in the Remote Control Using the Security Lock Troubleshooting Problem The projector is not running Problem Only the start-up screen displays Problem Image isn’t centered on the screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image is too wide or narrow for screen Problem Lamp shuts off Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Call Boxlight at 1-800-762-5757 or Specifications Appendix Accessories Standard Accessories ship with the projector Optional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate port FN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Using SimulScan Diagonal Maximum Minimum Projected Image SizeDistance to screen Image Width Index D e Page D e Limited Warranty Limitation of Liability