Status Menu, Lamp hours used, Computer resolution | BOXLIGHT XD-10m

Status Menu

This is a read-only menu for informational purposes. To display the Status menu, highlight Status from the Main menu, then press menu/select.

FIGURE 20

Status menu

Lamp hours used

Indicates how many hours the current lamp has been in use. The counter starts at zero hours and counts each hour the lamp is in use. Replace the bulb when the brightness is no longer accept- able. See “Replacing the Projection Lamp” on page 27 for details.

Computer resolution

Shows your computer’s resolution setting. To change this, go to your computer’s Control Panel and adjust the resolution in the Display tab. See your computer’s user’s guide for details.

Source

Indicates the active source, Data-Analog, Data-Digital, Compos- ite video, or S-video.

Version

Indicates the projector’s software version. This information is useful when contacting Technical Support.

25

Image 33

BOXLIGHT XD-10m manual Status Menu, Lamp hours used, Computer resolution, Source, Version

Contents

Page Safety Certifications FCC Warning CanadaEN 55022 Warning Trademarks Declaration of ConformityPage Table of Contents Index Appendix Safety Instructions Safety Definitions Safety SymbolsSafety Terms Important Operating Considerations Customer Service Introduction Image ResolutionCompatibility Unpacking the Projector T r o d u c t i o n Usage Guidelines If You Need Assistance Warranty Make sure the projector and the computer are turned off Setting UP the Projector T t i n g O j e c t o r Connecting a Computer Connecting a Video Player Turning Off the Projector Powering up the Projector and Adjusting the Image T t i n g O j e c t o r Using the Projector Basic Image AdjustmentAdjusting the Projector I n g O j e c t o r Using the Remote Control Using the Keypad and Remote Buttons Menu/selectSource keypad only or Data and Video remote only Keystone + remote only Reset keypad onlyForward/back buttons remote only Up/down arrow buttons Using the On-Screen Menus Display Menu KeystoneBrightness Tint ContrastColor Blank screen Image Menu for Computer Sources ResizeAuto Image Manual Tracking Manual SyncHorizontal Position Vertical Position Video Standard video sources only Image Menu for Video Sources Default Source Control MenuAuto Source Reset Advanced MenuRear Projection Language Menu Status Menu Computer resolutionLamp hours used Source I n g O j e c t o r Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the yellow tab on the lamp module Loosen the captive screw on the lamp module I n t e n a n c e Troubleshooting Using the Security Lock Replacing the Batteries in the Remote Control Problem Only the start-up screen displays Troubleshooting Problem The projector is not running Problem The screen resolution is not right Problem Color or text not being projectedProblem Image isn’t centered on the screen Problem Image is too wide or narrow for screen Problem Lamp seems to be getting dimmer Problem Image is noisy or streakedProblem Lamp shuts off Call Boxlight at 1-800-762-5757 or Appendix Specifications Standard Accessories ship with the projector Accessories Optional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation Chart FN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using SimulScan Using Video Mirroring with a PowerBook Computer Distance to screen Projected Image SizeDiagonal Maximum Minimum Image Width Index D e Page D e Limited Warranty Limitation of Liability