TTW1 Universal Service
Replacement Blower
MITW
Step 12. Find the rubber vent adapter kit, P/N
Note: In order to prevent condensate from draining back into the blower (vertical or horizontal runs), an optional condensate kit is available as a service part (Condensate kit, P/N
Step 13. If it has not already been done, remove the old vent adapter from the existing vent pipe.
Step 14. If necessary,
Step 15. Be sure that both clamps on the vent adapter are firmly tightened, securing the blower, vent adapter, and vent pipe together.
Be sure that vent pipe is properly seated in the top side of vent adapter.
Rubber vent
adapter
Adequately tighten both
clamps on the vent adapter.
Step 16.
Step 17. Restore electrical power to the water heater.
Plug power cord back into outlet.
Warning: | Check all safety devices to make sure they |
| are working properly. Improper water heater |
| operation could occur if these devices are not |
| functioning properly. |
Page 11