Brother 9200DX manual Installing P-touch Editor Version, Operating system

For Windows®

Installing P-touch Editor

Before labels can be printed on the PT-9200DX, the P-touch Editor software and the PT-9200DX printer driver must be installed.

P-touch Editor & Printer Driver Installation (for Windows® 95/98/Me/NT 4.0/2000 Professional/XP)

Install P-touch Editor Version 3.1 and the printer driver on a PC as described below.

Check that your system configuration meets the following requirements.

Computer: IBM PC or compatible

Operating system:

Serial interface: PC equipped with an x86 processor and a serial (RS-232C) port, and running Microsoft Windows® 95/98/Me/2000 Professional/XP or Windows® NT 4.0

USB interface: PC equipped with a USB port, and pre-installed with Microsoft® Windows® 98/Me/2000 Professional/XP

￿Some PCs pre-installed with Microsoft® Windows® 95/NT 4.0 do not support all USB hardware features.

Hard disk free space: At least 20 MB

￿A few hundred megabytes of additional free space may be needed when printing long labels or large amounts of data.

Monitor: VGA or higher graphics card

Port: Serial or USB

Available memory: Minimum 32 MB

CD-ROM drive

Installing P-touch Editor Version 3.1

￿For a serial connection: Before installing the P-touch Editor software and the printer driver, connect the PT- 9200DX to the computer as described on page 4, and then turn them on.

For a USB connection: Do not connect the PT-9200DX to the computer before installing the P-touch Editor software, otherwise it may not be installed correctly. Be sure not to connect the PT-9200DX until you are instructed to do so.

1 Insert the P-touch Editor Version 3.1 CD-ROM into	3 Click the top button (Editor). A dialogue box appears,
the computer’s CD-ROM drive. A dialogue box	allowing you to select the model.
automatically appears, allowing you to select the	￿ To install just the printer driver, click the lower
language.	button (Printer driver).

If the dialog box does not automatically appear, click “My Computer” on the desktop, and then double- click the CD-ROM drive containing the CD-ROM. (For Windows® XP, click “My Computer” in the Start menu, and then double-click the CD-ROM drive containing the CD-ROM.)

Next, double-click “Setup.exe” to display the dialog box.

2Select the language for the Windows® operating system that you are using, and then click the OK button. A dialogue box appears, allowing you to select what to install.

6