Brother 9200DX manual Installing P-touch Editor Version, Remove the CD-ROM from the computer

6If the dialog box warning that the software has not passed Windows Logo testing appears again, click the Continue Anyway button to continue with the installation (since this printer driver has already cleared strict product quality standards of our testing).

For Macintosh

7In the dialog box that appears, indicating that installa- tion is finished, select “Yes, restart immediately.”, and then click the Finish button. After the computer is restarted, the installation is fully completed.

8 Remove the CD-ROM from the computer.

P-touch Editor Version 3.1 Installation (for Macintosh)

Follow the procedure below to install the P-touch Editor software on the Mac.

The Mac version of the software is for a Mac with an English operating system. If the software is installed on a Mac with an operating system in a different language, the software may not run properly.

Check that your system configuration meets the following requirements.

Computer: Macintosh or Power Macintosh

Operating system:

Serial interface: Macintosh equipped with a PowerPC processor and a serial port (modem or printer), and running Mac OS 8.1 or later

USB interface: Macintosh equipped with a USB port and running Mac OS 8.5.1 or later

*For previous Mac OS versions, refer to the Apple Web site for information about USB.

*This software can only run on Mac OS X in the Classic environment. However, the Mac OS X v10.2 Classic environment is not supported.

*The application is supplied on a CD-ROM; therefore, the computer should be equipped with a CD-ROM drive.

Hard disk free space: At least 20 MB

￿A few hundred megabytes of additional free space may be needed when printing long labels or large amounts of data.

Port: Serial or USB

Available memory free space: Minimum 24 MB

CD-ROM drive

With the enclosed CD-ROM, the following can be installed:

•P-touch Editor Version 3.1

•PT-9200DX printer driver

Installing P-touch Editor Version 3.1

1Connect the PT-9200DX to the Macintosh using the enclosed interface cable. Be sure to leave the PT- 9200DX turned off.

2Turn on the Macintosh.

3Insert the P-touch Editor CD-ROM into the computer’s CD-ROM drive.

4Double-click the P-touch Editor 3.1 Installer icon in the folder that appears.

5After the installer starts up, select the installation method.

Clicking the Install button immediately starts installing the most basic options. (Some clip art illustrations are not installed.)

About 20 MB of available hard-disk space is needed to begin installation. In order to install all options, about 120 MB of available hard-disk space is needed. If enough hard-disk space is available, click the Install button.

12