Feeding Tape
Feed & Cut
The Feed & Cut function feeds 0.92" (23mm) of blank tape then cuts the tape.
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon to be discharged with the tape.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the tape to jam.
1 Hold down the Shift key and press the Preview key. "Feed & Cut?" will appear on the LCD display.
2Using the 
or 
key to select the "Feed & Cut" option and then press either OK or Enter.
The message "Feeding Tape... Please Wait" appears while the tape is fed, and then the tape is cut.
To exit or cancel this function press Escape.
z GETTING STARTED
Feed Only
This function will advance the tape approximately 0.92" (23 mm) resulting in a blank label sticking out of the tape cassette. This action is recommended when using Fabric and Extra Strength Adhesive tapes, which should be cut using scissors.
1Hold down the Shift key and press the Preview key. "Feed & Cut?" will appear on the LCD display.
2Using the 
or 
key to select the "Feed Only" option and then press either OK or Enter key.
The message "Feeding Tape... Please Wait" appears while the tape is fed.
To exit or cancel this function press Escape.
1
2
3
4
5
6
7
8
9
Feeding Tape
20 |
