Brother STAR-230E, STAR-240E Mode PS-57, PS-55, STAR-50, RSR-55, XRX-55, PS-53

КРАТКОЕ ТЕХНИЧЕСКОЕ ОПИСАНИЕ МАШИНЫ

KENNENLERNEN	KNOWINGYOUR
IHRERMASCHINE	SEWINGMACHINE

(Model STAR 240E, STAR 230E)

1

(Model PS-57, PS-55, STAR-50, RSR-55, XRX-55, PS-53)

12

(Model STAR 240E, STAR 230E)

4. Slide the sewing speed controller to its maximum (as far to the right as possible).

5. Push the Start/Stop button. The machine will stop automatically when the bobbin is full.

6. After the bobbin has stopped moving, push the Start/Stop button to stop the machine.

1 Sewing speed controller

CAUTION

When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, resulting in damage to the machine.

7.Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

(Mode PS-57, PS-55, STAR-50, RSR-55, XRX-55, PS-53)

4.Step down on the foot controller to start.

5.After the machine stops automatically when the bobbin is full, take your foot off of the foot controller.

CAUTION

When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, resulting in damage to the machine.

6.Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

NOTE:

The needle bar does not move when the bobbin winding shaft is slid to the right.

Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or manually turning the balance wheel.

CAUTION

Be sure to follow the process described. If the thread is not cut completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break.

CAUTION

Setting the bobbin improperly may cause the thread ten- sion to loosen, breaking the needle and resulting in injury.

1Wound evenly

2 Wound poorly

35