Cabletron Systems manual Installing Options, INSTALLING THE 6H122-08 INTO THE 6C105 CHASSIS

Chapter 3: Installation

3.3INSTALLING OPTIONS

NOTE

Install any optional equipment before proceeding to Section 3.4.

If the 6H122-08 will be installed with an optional Fast Ethernet Interface Module refer to Appendix C for installation instructions.

3.4INSTALLING THE 6H122-08 INTO THE 6C105 CHASSIS

Failure to observe static safety precautions could cause

!damage to the 6H122-08. Follow static safety handling rules

CAUTION	and properly wear the antistatic wrist strap provided with the
	6C105 chassis.

Do not cut the non-conductive bag to remove the module.

!Damage could result from sharp objects contacting the board

CAUTION or components.

The 6H122-08 can be installed in any of the 5 slots that are available. To install a module, proceed as follows:

1.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling. (Save the blank plate in the event you need to remove the module.)

2.Carefully remove the module from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

3.Locate the antistatic wrist strap shipped with the 6C105 chassis. Attach the antistatic wrist strap to your wrist and plug the cable from the antistatic wrist strap into the ESD grounding receptacle at the upper right corner of the 6C105.

3-2 6H122-08 User’s Guide