Cabletron Systems 6H122-08 manual 5.15.11 Configuring the COM Port

General Configuration Screen

5.15.11 Configuring the COM Port

Before altering the COM port settings, ensure that a valid IP

!address is set for the module or chassis. (Refer to

CAUTION	Section 5.15.1, Setting the IP Address). Read this entire
	COM port configuration section before changing the settings of
	the COM port.

The 6H122-08 COM port supports the following applications:

NOTE

Refer to the Release Notes included with the 6H122-08 to verify which COM Port applications are currently supported.

•Local Management connections

•American Power Conversion Uninterruptible Power Supply (UPS) connections

To configure the COM port, proceed as follows:

1.Use the arrow keys to highlight the Com field.

!

CAUTION

Do NOT disable or alter the settings of the COM port while operating the current Local Management connection through a terminal. Altering the COM port settings disconnects the Local Management terminal from the port, and ends the Local Management session.

2.Press the SPACE bar to choose either ENABLED or DISABLED. The COM port must be ENABLED if it will be used for Local Management or UPS applications. Select DISABLED if you wish to disable the COM port for additional module security.

If the COM port is reconfigured without a valid IP address set

!on the module or chassis, the message shown in Figure 5-20

CAUTION	displays. Do not continue unless the outcome of the action is
	fully understood.

6H122-08 User’s Guide 5-51