Cabletron Systems 6H122-08 manual Setting the Module Time, Entering a New Screen Refresh Time

Chapter 5: Local Management

5.15.6 Setting the Module Time

To set the module clock, perform the following steps:

NOTE

If the 6C105 chassis has been assigned a chassis time, it is not necessary to assign a module time to the 6H122-08. All installed modules recognize the chassis time of the 6C105.

1.Use the arrow keys to highlight the Module Time field.

2.Enter the time in an 24-hour format, HH:MM:SS.

NOTE

When entering the time in the system time field, separators between hours, minutes, and seconds do not need to be added as long as each entry uses two numeric characters. For example, to set the time to 6:45 A.M., type “064500” in the Module Time field.

3.Press ENTER to set the system clock to the time in the input field.

4.Use the arrow keys to highlight the SAVE command at the bottom of the screen and press ENTER.

If the time entered is a valid format, the Event Message Line at the top of the screen displays “SAVED OK”. If the entry is not valid, Local Management does not alter the current value and refreshes the Module Time field with the previous value.

5.15.7 Entering a New Screen Refresh Time

The screen refresh time is set from 3 to 99 seconds with a default of 3 seconds. To set a new screen refresh time, perform the following steps:

1.Use the arrow keys to highlight the Screen Refresh Time field.

2.Enter a number from 3 to 99.

3.Press ENTER to set the refresh time to the time entered in the input field.

4.Use the arrow keys to highlight the SAVE command at the bottom of the screen and press ENTER.

If the time entered is within the 3 to 99 seconds range, the Event Message Line at the top of the screen displays “SAVED OK”. If the entry is not valid, Local Management does not alter the current setting, but it does refresh the Screen Refresh Time field with the previous value.

5-48 6H122-08 User’s Guide