Cabletron Systems 6H122-08 manual Remove the screw from the rear standoff. Save the screw

Appendix C: Optional Installations and Mode Switch Bank Settings

Coverplate

Rear

Standoff

Front

Standoffs

2159-32

Figure C-3 Coverplate Removal

2.Remove the screw from the rear standoff. Save the screw.

When installing an FE-100FX or FE-100F3 module into the

!6H122-08, remove the rubber plug on the module before CAUTION proceeding.

3.See Figure C-4. Gently pull the faceplate of the 6H122-08 forward to allow room for the Fast Ethernet Interface Modules to be aligned over the connector.

4.Carefully lower the Fast Ethernet Interface Module onto the standoffs while inserting the module connector into the associated motherboard connector.

When inserting the Fast Ethernet Interface Module into the

!motherboard connector ensure that the pins do not bend, as

CAUTION	this can damage both the Fast Ethernet Interface Module and
	the motherboard connector.

C-6 6H122-08 User’s Guide