Chapter 3: Installation
Installing the FLASH SIMM
To install a FLASH SIMM, refer to Figure
1.Remove the chassis cover as described in Section 3.2.
2.Locate the FLASH SIMM slot. (See Figure
The internal components and boards associated with the ESX
!are static sensitive devices. Use the antistatic wrist band and
CAUTION | observe standard antistatic safety procedures when the cover |
| |
| is removed. Failure to do so could cause damage or severely |
| limit the life expectancy of the ESX. |
3.Insert the SIMM between the connector teeth in the SIMM slot.
4.Pivot the SIMM down until it locks into the clips in the SIMM slot, and the SIMM holes fit over the SIMM slot posts.
| SIMM Slot |
Connector | Clips |
Teeth |
|
| 1 |
2 | SIMM Slot |
Post | |
| |
| SIMM |
| SIMM Hole |
Figure 3-6 Installing a FLASH SIMM
|
