QDensity

1 to 5; 3*

This setting enables you to adjust the number density and has 5 levels you can adjust, with level '3' (middle level) being the default setting. Selecting '1' makes the number lighter, and selecting '5' makes it darker.

NOTE

This function is only available if 'Copy Set Numbering' is set to [On].

QNumber Position Vertical/Number Position Horizontal

-5/16 to +5/16 inches (in increments of 1/16 inches); 0* inches

The position of the copy numbers specified with 'Print Position' can be finely adjusted by offsetting them in the horizontal or vertical directions. The adjustment can be made from -5/16" (-8 mm) through +5/16" (+8 mm) in increments of 1/16" (1 mm).

You can increase or decrease the setting value to adjust the print position of the copy numbers, as described below.

Number Position Vertical: Increasing the setting value moves the print position in the downward direction of the paper. Decreasing the setting value moves the print position in the upward direction of the paper.

Number Position Horizontal: Increasing the setting value moves the print position to the right. Decreasing the setting value moves the print position to the left.

 

Horizontal "+" direction

 

direction"+"

 

 

 

 

Original print position of copy numbers

 

00001

00001

 

Vertical

 

 

 

00001

00001

 

 

 

 

 

 

 

 

 

 

 

 

IMPORTANT

Please note that if the print position is adjusted to place the digits of the copy numbers outside the printable area, the portion outside the printable area is not printed.

NOTE

šThis setting is only effective for the print position of copy numbers. When adjusting print position (other than the copy numbers), perform the setting with 'Offset Short Edge/Offset Long Edge'. (See p. 3-19to p. 3-20.)

šThis function is only available if 'Copy Set Numbering' is set to [On].

3

Printer Settings Menu

Settings Menu

3-41