Using an Eye-Fi Card

Images labeled with a [] icon have been transferred.

• Choosing [] mode will interrupt the Eye-Fi connection. Although the Eye-Fi connection will be restored after you choose another shooting mode or enter Playback mode, the camera may transfer any movies made in [] mode again.

Checking Connection Information

Check the access point SSID used by the Eye-Fi card or the connection status, as needed.

zzPress the <n> button, choose [Eye-Fi Settings] on the [3] tab, and then press the <m> button.

zzChoose [Connection info], and then press the <m> button.

XXThe connection information screen is displayed.

Disabling Eye-Fi Transfer

Configure the setting as follows to disable Eye-Fi transfer by the card, if necessary.

Choose [Disable] in [Eye-Fi trans.].

zzPress the <n> button, choose [Eye-Fi Settings] on the [3] tab, and then press the <m> button.

zzChoose [Eye-Fi trans.], and then choose [Disable].

•[Eye-Fi Settings] is not shown unless an Eye-Fi card is in the

camera with its write-protect tab in the unlocked position. For this reason, you cannot change settings for an inserted Eye-Fi card if the write-protect tab is in the locked position.

301