Installing and Removing the Battery

Load a fully charged Battery Pack LP-E4N/LP-E4 into the camera. The camera’s viewfinder becomes bright when a battery is installed, and darkens when the battery is removed.

Installing the Battery

 

1

Remove the battery compartment

 

cap.

2 Insert the battery.

 

Insert the battery firmly all the way,

 

and turn the release handle as shown

 

by the arrow.

Removing the Battery

Turn the battery release handle

 

and take out the battery.

 

Check if the power switch is set to

 

<2> (p.38).

 

Flip out the battery release handle,

 

turn it as shown by the arrow, and pull.

 

To prevent short circuiting of the

 

battery contacts, be sure to attach the

 

protective cover (provided, p.27) to

 

the battery.

 

When not using the camera, attach

 

the battery compartment cap (p.20).

Only the Battery Pack LP-E4N/LP-E4 can be used.

If the battery’s rubber lining (to repel water) is dirty, use a moist cotton swab to wipe it clean.

Rubber lining

34