Canon IR3300 manual Abc Def

3

Printer Settings Menu Functions and Operation

Offset X	-50.0 - 0.0 - +50.0 mm (in increments of 0.5 mm)
Offset Y
	This setting sets the offset position in mm. The settings can be set
	between -50.0 mm (-2.00 inch) to +50.0 mm (+2.00 inch) in increments of
	0.5 mm (0.01 inch).
	The print position is adjusted in the vertical or horizontal direction only to
	the value specified in the setting value.
	You can increase or decrease the setting in increments of 0.5 mm (0.01
	inch) to adjust the print position as described below.
	Offset X:	Increasing the setting value moves the image in the X
		direction on the paper. Decreasing the setting value moves
		the image in the X direction on the paper.
	Offset Y:	Increasing the setting value moves the image in the Y
		direction on the paper. Decreasing the setting value moves
		the image in the Y direction on the paper.

Area adjusted using

X-Adjustment

						X [+]			X
			using		Y			Y
ABC	DEF
			adjusted	Adjustment
					[+]		ABC			DEF
		Adjust using
		X/Y-Adjustment
			Area	Y
				-

IMPORTANT

•Please note that if the print position is adjusted to place print data outside the valid print area, the portion outside the valid print area will not be printed.

NOTE

• Pressing [ ] increases the setting value by 0.5 mm

(0.01 inch) each time the key is pressed. Pressing [ ] decreases the value by 0.5 mm (0.01 inch) each time.

Holding down either [ ] or [ ] continuously speeds up the value alteration.

3-10Settings Menu