Canon LU A 90, LU_A 80 Audio Recording, Changing AudiQ MQde, Using HeadphQnes during ReCording

Audio Recording

Changing	the AudiQ MQde	_	[-_
You can record	sound in two audio modes--16-bit	and 12-bit. The 12-bit	mode records

sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new sound later. Select the 16-bit mode for higher sound quality.

I

A00,0sEToP] [AO0,OMOOEJ

Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it

to [16bit] and close the menu.

"16bit" appears for approximately 4 seconds.

Using HeadphQnes during ReCording

The headphones terminal also serves as AV terminal. Headphones can only be used when "O" is displayed on the screen. If not, change the setting following the procedure below.

I

		1 m		J
_WENU	VCR SETUP	_AV/PHONES	9 • • AV
(_	38)	J[

Open the menu and select [VCR SETUP]. Select [AV/PHONES 9], set it to [PHONES Q] and close the menu.

=tl

==

¢n

MENU AUDIO SETUP

(C_38)

Open the menu and select [AUDIO SETUP]. Select [9 VOLUME], adjust the volume with the SET dial and close the menu.

You can turn off the volume completely by turning the SET dial down until [OFF] appears. Turn the SET dial up to increase the volume again.

61