Canon MP800 manual Times Absorbers

2 times	absorbers	Only the main waste ink absorber is valid for the MP800
3 times or	Not valid	Press the ON/OFF button to return to the waste ink
more		amount setting mode.

3)Press the ON/OFF button to proceed to the next step.

4)The waste ink amount can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset button the appropriate number of time(s) to select the value which is closest to the actual waste ink amount.

Time(s)	Waste ink amount value to be set (%)
0 times	0%
1 time	10%
2 times	20%
3 times	30%
4 times	40%
5 times	50%
6 times	60%
7 times	70%
8 times	80%
9 times	90%
	Not valid.

10 times or more

Press the ON/OFF button to return to the waste ink amount setting mode.

5)Press the ON/OFF button to set the selected value to the EEPROM. Print EEPROM information to confirm that the value is properly set to the EEPROM.

<LF correction procedures>

After replacement of the feed roller ass'y or logic board ass'y in repair servicing or in refurbishment operation, adjust the line feeding.

1)In the LF correction mode, press the Stop/Reset button the specified number of times according to the paper to be used in LF correction listed in the table below, then press the ON/OFF button.

Time(s)	Paper type	Paper name
1 time	High Resolution Paper	Canon HR-101
2 times		Canon PB PAPER GF-500, Office Planner
3 times	Plain paper	HP BrightWhite, OFFICE 80
4 times		Canon Extra, STEINBEIS

Note:

-The High Resolution Paper is the most desirable for LF correction printing (Canon HR-101 is used at the production site), but 6 kinds of plain paper listed in the table above can also be used in LF correction. If plain paper other than the above is used, select any one of the paper types in this step, then select Pattern No. 0 (zero) in the step 3) below.

-Each time the Stop/Reset button is pressed, the Alarm LED and the COPY button light alternately, Alarm in orange and COPY in green.

-If the Stop/Reset button is NOT pressed, and only the ON/OFF button is pressed, the machine remains in the LF correction mode.

-If the Stop/Reset button is pressed 5 times or more, then the ON/OFF button is pressed, the machine returns to the service mode menu selection.

2)The LF correction pattern for the selected paper is printed.

1-31