4.Turn on the power. This causes the Bridge Satellite Cradle power indicator lamp to light red.
5.Place the Handheld Printer Terminal so that the infrared communication unit on the right side is faced firmly with the infrared communication unit of the Bridge Satellite Cradle.
•If the system is operating normally and data communication is enabled, the system status indicator lamp lights green.
•The communication indicator lamp flashes green when data communication starts.
When charging is initiated, Indicator 1 (left side) on the Handheld Printer Terminal lights red. When charging has been completed, it changes the color from red to green.
*The indicator may light even if the battery pack is not installed. Make sure that the battery pack is installed when charging.
Important!
•A
In order to ensure successful communication, avoid using cellular phones or other devices that emit radio waves in the area where you are performing IR data communication.
If you need to use such a device, move it away from the communicating Handheld Printer Terminals. In case of a cellular phone, keep it at least 30cm (117⁄8") away.
•Take care to avoid allowing the Bridge Satellite Cradle power contacts to make contact with each other since this can cause.
Shorting the power contacts can damage the Bridge Satellite Cradle.
•If you print while charging, the battery will wear down since the amount of power discharged is greater than the amount of power supplied. Consequently, you may not be able to print if the battery power is excessively low.
