Installation

3 Attach the rail to the header bracket

3.1 Align the rail with the header

 

bracket. Insert the clevis pin (H12)

H19

through the holes in the header

H12

bracket and rail. Secure with the

 

ring fastener (H19).

 

4 Position the garage door opener

Tip: Use the packing material as a protective base for the garage door opener.

HARDWARE

H12

Clevis Pin 5/16"x1-1/2"

H19

Ring Fastener

To prevent damage to garage door, rest garage door opener rail on 2x4 placed on top section of door.

Tip: A 2x4 is ideal for setting the distance between the rail and the door.

If the ladder is not tall enough you will need help at this point.

4.1Remove the packing material and lift the garage door opener onto a ladder.

4.2Fully open the door and place a

2x4 (laid flat) under the rail. For one-piece doors without tracks, lay the 2x4 on its side.

One-piece door without tracks

All other door types

Tip: If the door hits the trolley when it is raised, pull the trolley release arm down to disconnect the inner and outer trolley. Slide the outer trolley toward the garage door opener. The trolley can remain disconnected until further instruction.

connected disconnected

14