Install the Protector System®
Option B2.1B Cut the end of the safety reversing sensor wire, making sure there is enough wire to reach the
2.2B Separate the safety reversing sensor wires and strip 7/16 inch (11 mm) of insulation from each end. Choose two of the
Safety reversing sensor wires
7/16" | ||
wires | ||
(11 mm) | ||
| ||
| 7/16" | |
| (11 mm) |
2.3B Connect the
Not Provided
White Yellow
(for example)
| ||
| wires | |
White/Black | Purple | |
(for example) | ||
|
Safety sensor wires
2.4B At the garage door opener, strip 7/16 inch (11 mm) of insulation from each end of the wires previously chosen for the safety reversing sensors. Twist the
Yellow
Purple
7/16" (11 mm)
2.5B Insert the wires connected to the white safety sensor wires to the white terminal on the garage door opener. Insert the wires that are connected to the white/black safety sensor wires to the grey terminal on the garage door opener.
Yellow (for example) | Purple (for example) |
RED | WHITE | EWHIT | GREY |
To insert or remove the wires from the terminal, push in the tab with a screwdriver tip.
26