Adjustments 
1 Program the Travel
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
•Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
•After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
1.1Press and hold the Adjustment Button until the UP Button begins to flash and/or a beep is heard.
1.2Press and hold the UP Button until the door is in the desired UP position
NOTE: The UP and DOWN Buttons can be used to move the door up and down as needed.
1.3Once the door is in the desired UP position press and release the Adjustment Button. The garage door opener lights will flash twice and the DOWN Button will begin to flash.
1.4Press and hold the DOWN Button until the door is in the desired DOWN position.
NOTE: The UP and DOWN Buttons can be used to move the door up and down as needed.
1.5Once the door is in the desired DOWN position press and release the Adjustment Button. The garage door opener lights will flash twice and the UP Button will begin to flash.
1.6Press and release the UP Button. When the door travels to the programmed UP position, the DOWN Button will begin to flash.
1.7Press and release the DOWN Button. The door will travel to the programmed DOWN position. Programming is complete.
*If the garage door opener lights are flashing 5 times during the steps for Program the Travel, the programming has timed out. If the garage door opener lights are flashing 10 times during the steps for Program the Travel, the safety reversing sensors are misaligned or obstructed (refer to page 28). When the sensors are aligned and unobstructed, cycle the door through a complete up and down cycle using the remote control or the UP and DOWN buttons. Programming is complete. If you are unable to operate the door up and down, repeat the steps for Programming the Travel.
30