Door Control

SYNCHRONIZE THE DOOR CONTROL

To synchronize the door control to the garage door opener, press the push bar until the garage door opener activates (it may take up to 3 presses). Test the door control by pressing the push bar, each press of the push bar will activate the garage door opener.

USING THE DOOR CONTROL

The following features are accessible through the screen using the navigation buttons on the Smart Control Panel or by lifting the push bar on the Motion-Detecting Control Panel:

LEARN A DEVICE

Any compatible remote controls, wireless keyless entry, or MyQ™ accessories can be programmed to the garage door opener by accessing the menu and using the navigation buttons on the Smart Control Panel or by pressing the Learn button on the Motion-Detecting Control Panel.

SMART CONTROL PANEL

MOTION-DETECTING CONTROL PANEL

LOCK

Push Bar

Navigation

Buttons

LIGHT

button Motion Sensor

Push Bar

 

1 Minute

HOLD OPEN

Button for the

TTC LED

Timer-To-Close

 

(TTC)

5 Minute

LIGHT

TTC LED

Button

10 Minute

Motion

Sensor

TTC LED

 

The LOCK feature is designed to prevent activation of the garage door opener from remote controls while still allowing activation from the door control and keyless entry. This feature is useful for added peace of mind when the home is empty (i.e. vacation).

TIMER-TO-CLOSE (TTC)

DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors. Factory default is set to off. TTC can be set to automatically close your garage door from the fully open position after a specified period of time (1, 5, 10 minute intervals). The Smart Control Panel also has a custom setting up to 99 minutes. The garage door opener will beep and the lights will flash before closing the door. The screen on the door control will display the status of the TTC such as time to close, paused, or an error. If the door encounters an obstruction while closing, the garage door opener will make a second attempt to close the door. If the obstruction has not been cleared after the second attempt, the

PUSH BAR

Press the push bar to open or close the door.

LIGHT BUTTON

 

Press the LIGHT button to turn the garage door opener lights on or off. When the lights are

 

turned on they will stay on until the LIGHT button is pressed again, or until the garage door

 

opener is activated. Once the garage door opener is activated the lights will turn off after

 

the specified period of time (the factory setting is 4-1/2 minutes). The LIGHT button will not

 

control the lights when the door is in motion. The duration of the light timing can be adjusted

 

using the door control.

 

NAVIGATION BUTTONS (SMART CONTROL PANEL ONLY)

 

Use the navigation buttons to make selections and program features.

 

SCREEN (SMART CONTROL PANEL ONLY)

 

The screen will display the time and temperature until the menu button is pressed, and then

 

it will display the menu options. If there is a problem with the garage door opener the screen

 

will display the Diagnostic Code. Refer to the Troubleshooting section.

36

 

garage door opener will reverse open, stop and WILL NOT close until the obstruction has been cleared. TTC WILL NOT work if the garage door opener is operating by battery power or if the safety reversing sensors are misaligned. This feature is NOT intended to be the primary method of closing the door. A keyless entry should be installed in the event of an accidental lock out when using this feature.

AUTOMATIC LIGHTMotion Sensor

Factory default is set to on. This feature will automatically turn on the garage door opener lights when motion is sensed. The lights will come on for the set period of time, then shut off. If using the garage door opener light as a work light disable the Automatic Light Feature, otherwise the light will turn off automatically if you are beyond the range of the sensor.

The lights will turn on when someone enters through the open garage door and the safety reversing sensor infrared beam is broken.