TIMER-TO-CLOSE (TTC)
NOTE: DO NOT enable TTC if operating a
Activate:
Press and hold the ON button until one of the TTC LEDs light up.
Then press the ON button again to cycle through the time interval options (the corresponding TTC LED will light for each time interval). The garage door opener light bulbs will blink as confirmation.
Deactivate:
Press and hold the OFF button until all TTC LEDs turn off and a beep is heard from the motor unit.
Temporarily hold door open (suspend TTC):
Press and release the HOLD OPEN button. Press the HOLD OPEN button again to resume normal TTC operation.
1 Minute | ON |
TTC LED | Button |
| OFF |
| Button |
5 Minute |
|
TTC LED | HOLD OPEN |
| |
10 Minute | Button |
TTC LED |
|
LOCK
Activate:
Press and hold the LOCK button for
2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume.
Command LED
LOCK Button
LIGHT
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated by the number of flashes.
NUMBER OF TIMES | TIME THE GARAGE |
GARAGE DOOR | DOOR OPENER |
OPENER LIGHTS FLASH | LIGHT STAYS ON |
|
|
1 | 1 ½ Minutes |
2 | 2 ½ Minutes |
3 | 3 ½ Minutes |
4 | 4 ½ Minutes |
To cycle through the time intervals repeat the step above.
LIGHT FEATURE
Deactivate:
Press and hold the LIGHT button until the garage door opener lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then on again.*
LOCK
Button
LIGHT 
Button
*Approximately 10 seconds
37
MOTION SENSOR
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
Motion
Sensor
Switch
Motion
Sensor