Install the Protector System®
1 Install the Safety Reversing Sensors
The safety reversing sensors can be attached to the door track, the wall, or the floor. The sensors should be no more than 6 inches (15 cm) above the floor. If the door track will not support the sensor bracket a wall installation is recommended. Choose one of the following installations.
HARDWARE
H17 (2)Carriage Bolt
Wing Nut
|
|
|
|
|
|
|
|
|
|
|
| 1.1A Slide the curved arms of the |
|
| 1.2A Slide the carriage bolt (H17) into |
|
| 1.3A Insert the bolt through the hole in |
| ||
| sensor bracket around the edge |
|
| the slot on each sensor. |
|
| the sensor bracket and attach with |
| ||
| of the door track. Snap into place |
|
|
|
|
| the wing nut (H18). The lenses on |
| ||
| so that the sensor bracket is flush |
|
|
|
|
| both sensors should point toward |
| ||
| against the track. |
|
|
|
|
| each other. Make sure the lens |
| ||
|
|
|
|
|
|
|
| is not obstructed by the sensor |
| |
|
| no more |
|
|
|
|
| |||
|
| than 6 inches |
|
|
|
| bracket. |
| ||
|
|
|
| |||||||
|
| (15 cm) |
| H17 |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| H18 | |||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
If additional clearance is needed an extension bracket (not provided) or wood blocks can be used. Make sure that each bracket will have the same amount of clearance so they will align correctly.
1.1B Position the sensor bracket against the wall with the curved arms facing the door. Make sure there is enough clearance for the beam to be unobstructed. Mark holes.
Inside | (not provided) | ||
Garage |
|
|
|
Wall |
|
| no more |
|
|
| |
|
|
| than 6 inches |
|
|
| |
|
|
| (15 cm) |
1.2B Drill 3/16 inch pilot holes for each sensor bracket and attach the sensor brackets to the wall using lag screws (not provided).
de |
|
Ins | (not provided) |
Garage | |
Wall |
1.3B Slide the carriage bolt (H17) into the slot on each sensor.
H17
Lens
1.4B Insert the bolt through the hole in the sensor bracket and attach with the wing nut (H18). The lenses on both sensors should point toward each other. Make sure the lens
is not obstructed by the sensor bracket.
ll Wa
H18
24