
1 Install the Safety Reversing Sensors
Option C FLOOR INSTALLATIONUse an extension bracket (not provided) or wood block to raise the sensor bracket if needed.
1.1C Carefully measure the position of both sensor brackets so they will be the same distance from the wall and unobstructed.
Inside
age
Gar
Wall
1.2C Attach the sensor brackets to the floor using concrete anchors (not provided).
(not provided)
| e |
Insid | |
G | arage |
ll | |
Wa |
1.3C Slide the carriage bolt (H17) into the slot on each sensor.
H17
1.4C Insert the bolt through the hole in the sensor bracket and attach with the wing nut (H18). The lenses on both sensors should point toward each other. Make sure the lens is not obstructed by the sensor bracket.
H18
sde
In age Gar Wall
2 Wire the Safety
Reversing Sensors
HARDWARE
Insulated Staple (30)
2.1A Run the wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with the staples.
Staple
2.2A Strip 7/16 inch (11 mm) of insulation from each set of wires. Separate the wires.
Twist the white wires together. Twist the white/black wires together.
2.3A Insert the white wires into the white terminal on the garage door opener. Insert the white/black wires into the grey terminal on the garage door opener.
REDWHITEWHITEGREY
7/16"
(11 mm)
To insert or remove the wires from the terminal, push in the tab with a screwdriver tip.
25