Install the Door Control

1 Install the door control

To prevent possible SERIOUS INJURY or DEATH from electrocution:

•Be sure power is NOT connected BEFORE installing door control.

•Connect ONLY to 24 VOLT low voltage wires.

To prevent possible SERIOUS INJURY or DEATH from a closing garage door:

•Install door control within sight of garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and away from ALL moving parts of door.

•NEVER permit children to operate or play with door control push buttons or remote control transmitters.

•Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.

•ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path of closing garage door.

INTRODUCTION

Compatible with MyQ™ and Security✚ 2.0™ accessories. NOTE: Older Chamberlain accessories and third party products are not compatible.

Your garage door opener is compatible with up to 2 Security✚ 2.0™ door controls.

Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children cannot reach, and away from the moving parts of the door.

NOTE: Your product may look different than the illustrations.

HARDWARE

Screw 6ABx1-1/2" (2)

Screw 6ABx1-1/4" (2)

Screw

6-32x1" (2)

Drywall Anchors (2)

NOTE: For gang box installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.

1.1Strip 7/16 inch (11 mm) of insulation from one end of the wire and separate the wires.

7/16"

(11 mm)

1.2Connect one wire to each of the two screws on the back of the door control. The wires can be connected to either screw.

PRE-WIRED INSTALLATIONS: Choose any two wires to connect, but make note of which wires are used so that the correct wires are connected to the garage door opener in a later step.

1.3Mark the location of the bottom mounting hole and drill a 5/32 inch (4 mm) hole.

1.4Install the bottom screw, allowing 1/8 inch (3 mm) to protrude from the wall.

DRYWALL

GANG BOX

Drywall Anchor

6ABx1-1/2"6-32x1"

21